- Check that the tyre tread is not worn excessively.

Some types of tyre are fitted with wear gauges; they should be replaced as soon as these gauges are visible on the tread.

Do not swap tyres across.

- Check the tyre inflation pressure is correct, spare wheel included.

The tyre inflating pressures must be checked when they are cold.

- Check that the lighting system is working properly: headlamps, direction indicators, hazard warning lights, load compartment light, passenger compartment light and instrument panel warning lights.

- Check the windscreen washer/wiper system is operating correctly and adjust the sprays if necessary.

- Check that the front and rear wiper blades are correctly positioned and not worn.

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage.

- Visually inspect the condition of: exterior bodywork and underbody protection, pipes (exhaust, fuel system, brakes), rubber elements (boots, hoses, bushes, etc.) and fuel system and braking system flexible pipes.

- Check and clean the lower guides for versions with side sliding doors (or every 6 months).

- Check condition and wear of the front disc brake pads and operation of front pad wear indicator.

- Check the condition and wear of the rear brake pads and the operation of the rear disc brake pad wear indicator (where fitted).

- Check and, if necessary, adjust the handbrake lever travel; refer to

    Op. 3380A04 HANDBRAKE - ADJUST TRAVEL

- Check exhaust emissions/fumes; refer to

    Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT

    Op. 1080A20 EXHAUST FUMES - CHECK WITH OPACIMETER

- Change engine oil and filter; refer to:

    Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

L’effettivo intervallo di sostituzione dell’olio e del filtro olio motore dipende dalle condizioni di utilizzo del veicolo e viene segnalato tramite spia o messaggio (ove previsto) sul quadro strumenti e comunque deve essere effettuato ogni 24 mesi.

Nel caso di utilizzo del veicolo prevalentemente su percorsi urbani, si rende necessaria la sostituione dell’olio e del filtro olio motore ogni 12 mesi.

- Replace the diesel filter; refer to:

    Op. 1044B10 FUEL FILTER ASSEMBLY - R.R. OR REPLACE

- Replace the air cleaner cartridge; refer to:

    Op. 1048A14 AIR FILTER FILTER ELEMENT - REPLACE

Nel caso in cui il veicolo sia dotato di filtro aria specifico per zone polverose, occorre ffettuare:

- ogni 20.000 km controllo e pulizia filtro aria,

- ogni 40.000 km sostituzione filtroo aria.

- Replace the pollen filter; refer to:

Op. 5010B08

- Top-up the brake-clutch fluid level; refer to:

    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY

- Top-up engine coolant level; refer to:

    Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND TOP UP LEVEL IF NECESSARY

- Top-up power steering fluid level; refer to:

    Op. 0010T71 POWER STEERING FLUID - CHECK LEVEL AND TOP UP IF NECESSARY

- Top-up the screen washer fluid level.

- Check the accessory drive belt tension.

- Sostituire la cinghia dentata comando distribuzione; fare riferimento a:

    Op. 1032B10 TOOTHED TIMING BELT - R.R. FOR TIMING OR REPLACEMENT

Indipendentemente dalla percorrenza chilometrica, la cinghia comando distribuzione deve essere sostituita ogni 4 anni per impieghi severi (climi freddi, uso cittadino, lunghe permanenze al minimo) o comunque ogni 5 anni.

- Check the operation of the engine management control systems (using the diagnosis socket).

- Check the charge conditions of the battery and recharge, if necessary.

At the end of the service, connect the Examiner diagnosis equipment to the on-board diagnosis socket to reset the day mileage counter to the starting value and write the details of the service carried out (date, service no., total mileage) to the Trip Computer memory which can only be read using the diagnosis equipment.

Check that the measurement unit set in the instrument panel is the one used in that country - km or miles.