Refitting

- Set the height of the vehicle at level 3 using the adjustment buttons in the dashboard.

- Deactivate the self-levelling suspension control system by simultaneously pressing the two adjustment buttons in the dashboard (for at least 5 secs.) and the LEDs in the buttons should both come on constantly.

- Position the vehicle on the lift.

1. Undo the bolts (1a) fixing the Panhard bar (1b), then remove it.

Removing

- Check that the Panhard bar is not damaged, otherwise it must be replaced.

1. Place the Panhard bar (1a) in position then screw in the fixing bolts (1b) without tightening them.

1. Position a hydraulic lift (1a) at the rear axle (1b) centre line.

1. Raise the rear axle (1a) until the distance measured between the lower surface (1b) of the actual axle and the lower surface (1c) of the assembly support (1d) (measured at the point shown in the diagram) is equal to 210 mm.

- Tighten the bolts fixing the Panhard bar to the recommended torque.

- Remove the hydraulic lift.

- Lower the lift.

- Reactivate the self-levelling suspension control system by simultaneously pressing the two adjustment buttons in the dashboard (for at least 5 secs.) and the LEDs in the buttons should both go out.

- Carry out the sensor calibration procedure.

    Op. 0520G66 SELF-LEVELLING SUSPENSION - CALIBRATION OF SPING POSITION SENSOR USING EXAMINER

- Check that the system is working properly by carrying out a height alteration cycle.

- Remove the vehicle from the lift.