X007 CLIMATE CONTROL SYSTEM GAS LEAK FROM PRESSURE SWITCH

		Test results
1	CLIMATE CONTROL SYSTEM GAS CHARGE CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Check that the gas charge in the system is correct	Go to Step 2	Gas charge not correct	Restore the correct gas charge
2	LEAKAGE CHECK ON THE CLIMATE CONTROL SYSTEM CIRCUIT	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	With the engine running and the climate control system on (compressor button ON), check that the leak is by the system pipe housings or the seat for the drier filter or the pipe couplings on the evaporator assembly	Go to Step 3	Leakage identified on the climate control system circuit	Restore the seal of the circuit or, if necessary, replace the evaporator assembly
3	CLIMATE CONTROL SYSTEM O-RING CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Withdraw the pipes from the compressor and make sure that the O-rings on the pipes are correctly positioned; specifically check whether there has been pinching	Go to Step 4	O-ring seal failure	Replace the O-rings and refit the pipes on the compressor
4	PIPES/EVAPORATOR/EXPANSION VALVE/COMPRESSOR CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Check that the leakage is on other components of the cooling system, specifically other components/pipes of the cooling system, the evaporator or the compressor	End of diagnosis	Leakage detected on the examined components	Restore the seal of the components on which the leakage has been detected and, if necessary, replace them