P061D Control unit faulty (EGR drive)

			Test results
1	COMPONENT CONCERNED	CHECK WIRING BETWEEN HIGH PRESSURE EGR SOLENOID VALVE AND ENGINE CONTROL MODULE	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Wiring between high pressure EGR valve and powertrain control module	Check the continuity of the wiring between high pressure EGR valve and PINS 35 and 50 of the powertrain control module	Go to Step 2	Breaks in the wiring continuity	Restore the correct continuity of the wiring
2	COMPONENT CONCERNED	CHECK USING DIAGNOSIS EQUIPMENT	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	High pressure EGR valve	Connect the diagnostic tool to the powertrain control module, go to the “ACTUATORS” menu and launch procedure “EGR DC Motor”. Check the outcome of the test	Go to Step 3	The test did NOT have a positive outcome	Replace the high pressure EGR valve Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R
3	COMPONENT CONCERNED	CHECK USING DIAGNOSIS EQUIPMENT	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	High pressure EGR valve	Check for other error codes stored in the powertrain control module	End of diagnosis	Additional errors stored in the Powertrain Control Module	Follow the instructions provided by the diagnostic tool to resolve the errors