|
 Removing
(
Refitting
)
- Deactivate the self-levelling suspension control system by simultaneously pressing the two adjustment buttons in the dashboard (for at least 5 secs.) and the LEDs in the buttons should both come on constantly. - Position the vehicle on the lift. - Remove the control unit / compressor module guard. Op. 4430B13 SELF-LEVELLING SUSPENSION SYSTEM COMPRESSOR/CONTROL UNIT MODULE GUARD - R.R. |
|
 |
1. Disconnect the compressor air intake pipe (1a) through the rapid connector (1b) and release it from the retaining clip (1c). |
 |
1. Release the pipe (1a) from the retaining clips (1b) then remove it complete with filter (1c). |
|
|
Refitting
(
Removing
)
- Check that the pipe is not damaged and that the filter is not blocked or broken, otherwise they must be replaced. - Position the pipe complete with filter securing it to the bodyshell using the clips. - Connect the pipe to the compressor inserting it in the rapid connector for the actual compressor. - Position the control unit / compressor module guard. Op. 4430B13 SELF-LEVELLING SUSPENSION SYSTEM COMPRESSOR/CONTROL UNIT MODULE GUARD - R.R. |
|
- Lower the lift. - Reactivate the self-levelling suspension control system by simultaneously pressing the two adjustment buttons in the dashboard (for at least 5 secs.) and the LEDs in the buttons should both go out. - Check that the system is working properly by carrying out a height alteration cycle. - Remove the vehicle from the lift. |