Refitting

- Position the vehicle on the lift.

- Using the adjustment buttons in the dashboard, deactivate the system pressing them simultaneously for at least 5 secs. and the LEDs in the buttons will both come on constantly.

- Turn the ignition key to the OFF position.

- Remove the battery cover.

Op. 5530B54

- Disconnect the negative battery terminal.

1. Undo the nut (1a) fixing the ball joint (1b) for the rod (1c) for the position sensor.

1. Disconnect the self-levelling suspension position sensor electrical connector.

2. Undo the bolts (2a) fixing the sensor (2b), then remove it.

Removing

- Check that the sensor is not damaged, otherwise it must be replaced.

1. Position the sensor (1a) then secure it to the mounting bracket (1b) using the bolts (1c).

2. Connect the self-levelling suspension position sensor electrical connector.

1. Rotate the sensor (1b) arm (1a) so that it is facing the rear of the vehicle.

2. Place the ball joint (2a) for the rod (2b) for the position sensor in position and tighten the fixing nut (2c).

- Lower the lift.

- Connect the negative battery terminal.

- Position the battery cover.

Op. 5530B54

- Remove the vehicle from the lift.

- Reactivate the self-levelling suspension control system by simultaneously pressing the two adjustment buttons in the dashboard (for at least 5 secs.) and the LEDs in the buttons should both go out.

- Carry out the sensor calibration procedure.

    Op. 0520G66 SELF-LEVELLING SUSPENSION - CALIBRATION OF SPING POSITION SENSOR USING EXAMINER

- Check that the system is working properly by carrying out a height alteration cycle.