Refitting

- Set the height of the vehicle at level 3 using the adjustment buttons in the dashboard.

- Deactivate the self-levelling suspension control system by pressing the two adjustment buttons in the dashboard simultaneously (for at least 5 secs.) and the LEDs in the buttons will both come on constantly.

- Position the vehicle on the lift.

1. Undo the nuts (1a) securing the anti-roll bar to the joints (1b) (on both sides).

2. Undo the nuts (2a) securing the anti-roll bar (2b) to the bodyshell (on both sides) then remove it.

Removing

- Check that the anti-roll bar is not damaged, otherwise it must be replaced.

- Place the anti-roll bar in position then screw in the fixing bolts without tightening them.

- Screw in the nuts fixing the anti-roll bar to the joints without tightening them.

1. Place a hydraulic lift (1a) at the rear axle (1b) centre line.

1. Raise the rear axle (1a) until the distance measured between the lower surface (1b) of the actual axle and the lower surface (1c) of the support for the unit (1d) (measured at the point illustrated) is equal to 210 mm.

- Tighten the bolts securing the anti-roll bar to the body to the specified torque.

- Tighten the nuts securing the anti-roll bar to the joints to the specified torque.

- Remove the hydraulic lift.

- Lower the lift.

- Reactivate the self-levelling suspension control system by pressing the two adjustment buttons in the dashboard simultaneously (for at least 5 secs.) and the LEDs in the buttons will both go off.

- Check that the system is working properly by carrying out a height variation cycle.

- Remove the vehicle from the lift.